Create Wi-Fi Hotspot using some command

 

Manual for make hosted network using the command prompt in Windows 10 PC. The same steps can be applied to Windows 7 and Windows 8.1 running PCs. This aide will help you to make Wi-Fi Hotspot in Windows 10 PC using the command prompt and with no outside programming utility. 

The vast majority of us have wired internet connection on our PC. if you have a  lan internet connection or if you use the internet through 3G or 4G dongle on your PC, you can share the Internet by making a Wi-Fi hotspot in Windows 10

The facilitated system highlight in Windows 10 permits you to make a Wi-Fi hotspot and afterward share it to your other Wi-Fi-enabled devices, for example, tablets, cell phones, and portable PCs or PCs which has Wireless card installed

Microsoft does not give any direct UI to make Wi-Fi hotspot in Windows 10, but you can make it using few lines of commands. Here are the means by which to make Wi-Fi hotspot in Windows 10 using the command prompt method.

  1.  Press the "Windows key" + "R" buttons at the same time. The Run window will pop up.
  2.  Type "cmd" and hit "Enter". The Command Prompt will pop up, with Administrative Privileges.
    netsh wlan set hostednetwork mode=allow ssid=wifi_name key=password
    netsh wlan start hostednetwork
    Here Name & password replaced by your wi-fi zoon name and password .
  3. create wifi zoon in your laptop
    Go to Control Panel, Network and Internet and open Network Connection. Or copy and paste this  commands “Control Panel\Network and Internet\Network Connections” in Windows Explorer.

    Right-click on your current web association and select Properties.
     
    sharing your pc wifi


  4. From the properties window, click on Sharing tab.
    Check “Allows other network users to connect through this computer’s Internet connection.”
    Click on “Select a Private Network” and select the newly created Wi-Fi connection from the drop down list.
    pc net sharing set up

Click on the OK and close the properties window. 


Presently on the off chance that you go to Network and Sharing Center in Control Panel, you will see your recently made Wi-Fi association recorded in dynamic systems segment.

Take out your phone, tablet and laptop and start Wi-Fi using.
Enjoy its......
You can stop Wi-Fi connection either

netsh wlan stop hostednetwork
stop wifi zoon

Note: You can alway create a new Wi-Fi hotspot using the same command. Every new Wi-Fi connection will overwrite the previous one.
Create Wi-Fi Hotspot using some command  Create Wi-Fi  Hotspot using some command Reviewed by Unknown on 00:08:00 Rating: 5

No comments:

Powered by Blogger.